Install Flashing Awning

This video shows how to install endwall flashing with standing seam panels.

Install flashing awning. Flashing is generally installed at any joints or edges in the roof where water could otherwise work its way in. Nail the flashing securely in place using roofing nails. Typically flashing is installed using roofing nails and roofing cement. Step 6 make a 10 degree bend on the shingle edge of the flashing approximately 1 2 inch from the edge.

4 inches should go up the house wall and 4 inches should go on top of the porch roof shingles. However the principles are the s. Install the flashing place the flashing between the joint of the house and the roof. The flashing on the wall should be flush against it and the porch roof portion should be on top of the shingles.

Install waterproof flashing onto the bottom of the timber awning window frame staple a strip of waterproof flashing onto the rear of the window frame so it can fold underneath and cover the base. Be sure to leave yourself plenty of overhang on either side. In order to properly install new flashing you ll have to remove the shingles surrounding your old flashing and then re lay them after installation. Use the metal break tool to bend the flashing lengthwise in the middle according to the angle of the roof joint.

Install a reverse peak flashing for the other side of the roof so the two wall edges overlap in an x nail step flashing at a peak so the roof side extends over peak flashing on the roof.