Install Roof Shingles Valley

Fasten the shingles about 6 inches away from the centerline on both sides.

Install roof shingles valley. Press the shingle into the valley and make sure that it is flat against the surface of the roof. Others start with a 3 inch wide. Place a roofing nail in each corner and one in the center on its appropriate side. Snipping off the corners of.

Place a piece of sheet metal under the shingles to make sure you will not damage the flashing. Quick guide how to install an open valley. Starting at the bottom edge of the valley begin laying down the shingles. To secure the roof valley flashing nail it down carefully.

Always install flashing around a chimney and other valleys where two roof planes meet as these areas are more prone to leaks if not protected. Some roofers cut the shingles parallel to the flashing s center ridge. Cut the tabs off of one shingle and lay it on the bottom edge with a 1 4 inch overhang. Only nail at the edges with only enough nails to.

Start by laying all shingles on one side of the roofing and stretch it across the valley. Draw a 2 inch self stick flashing down the center. Stretch it about 12 inches across the centerline. Install new flashing metal flashing is often called drip edge along the bottom of the roof near your gutters.

To shingle out of the valley with laminated shingles lay a shingle down as a gauge and mark the corner at the bottom left and top right of the roof. Trim the shingles to these lines and cut a 5 cm triangle off the top corner to direct the water into the valley. Ensure ice and water protector has been installed along the valley first. Nail the shingles 5 cm back.

I then move the shingle to the uppermost course on the roof plane line up the mark on the shingle with the valley center and again mark the corner. Nail the drip edge in place using your hammer and roofing nails.