Installing Gutter Pops
We provide a fully licensed plumber to do all your gutter.
Installing gutter pops. Snap the sections together. Here are the steps to installing a pop up gutter drain system. Cut a two inch long notch in the front lip of the gutter with tin snips to join a rain gutter section. Form strip miter joint at corner cover the joint between two lengths of gutter at each corner with a strip miter a 3 inch wide strip of aluminum.
Then trim the first section of the gutter to length with tin snips. Wrap the aluminum strip tight around the underside of the gutter. Snap a chalk line between the start and end of the gutter run. These drains are attached to the end of a pipe that runs underneath the surface of your yard.
Use a square and pencil to mark the gutter length and cut to the line. Firmly hit the top of the nails with a hammer to drive them into each point. Dig a hole underneath your gutter downspout and place a catch basin in the hole. How to install a pop up gutter drain.
Project step by step 20 cutting the gutter. Begin by installing a slip joint splice on each end of an inside corner fitting. Slide the splices on as far as they ll go. Cut a triangular section from.
It s much easier to join sections on the ground than to work from the top of a ladder.